Very poor fit in cooler
I purchased both the Short and Long Dividers for a brand new Tundra 75 cooler (knowing they cannot be used at the same time). The Short Divider was actually too big to fit into the cooler without forcing it. I was concerned about damaging the walls of the cooler, but I was able to sand down one edge of the divider until it fit into the cooler perfectly. I needed to remove a lot of material, but I was able to get it to fit. The Long Divider had the exact opposite problem. It was so short in the cooler that it wouldn't catch in both slots at the same time. If the Long Divider was seated properly in one groove, the other end moved freely outside of its intended groove. Yeti replaced this Long Divider with another one, but it had the same problem and I ended up having to return it. I don't know how the other different coolers work with their dividers, but the dividers for the Tundra 75 don't seem to fit properly. I could sand down the Short Divider to make it fit, but there's no way to stretch one that's too small. They need to look at the specs on these dividers, but Yeti customer service handled the initial exchange, and then the return, fairly quickly.